CDA CERAMIC HOBS HVC65 - Manual (Page 9)

8
Safety Features
The childlock
The hob is equipped with a childlock to lock all the controls except , for safety reasons. This can be used when the hob is off
or during cooking.
To set the childlock
Touch to switch the hob on.
Touch the front right zone and at the same time.
Touch the front right zone . L will show on all zone displays.
To suspend the childlock for cooking once it is set
Touch the front right zone and at the same time.
The zone displays will show 0 to confirm the zones can be switched on. Then set the zones as required. The childlock will
switch on automatically approximately twenty seconds after programming is complete, and L will show on all zone displays.
To turn off the childlock
Touch the front right zone and at the same time.
The zone displays will show 0 to confirm the zones can be switched on.
Touch to switch the childlock off.
Residual Heat Indicators
The hob is equipped with residual heat indicators to warn when any of the zones are still hot to the touch after cooking.
An H will show in the relevant zone display after cooking until the zone is at a safe temperature to touch.
Please note:
You should avoid touching the zones when the hob is in use, or when an H is showing on the zone display.
In the event of a power cut, the residual heat indicators will illuminate after the power supply is restored. However, when there
is no power supply to the hob the residual heat indicators will not work, so extra care must be taken.
Temperature Limiter
The hob is equipped with a temperature limiting sensor that adjusts the power output of the hob if the bottom of the
cookware becomes too hot, preventing damage to the cookware and to the hob itself.