Casablanca Fan Company Casablanca 19th Century - Manual (Page 4)

3
PREPARATION INSTRUCTIONS
Unpacking: Before assembling and installing your ceiling fan, remove all parts from the shipping cartons and check them
against the parts listed here. Before discarding packaging material, be certain that all parts have been removed.
DOWNROD COVER
DOWNROD & BALL
ASSEMBLY
PERMA•LOCK™ HARDWARE
GETTING STARTED
Carton Contents
The fan carton contains the fan body, warranty card, owner's
manual, and all the parts necessary to assemble and install your
Casablanca ceiling fan. These parts are shown at the start of
each installation section. Before you start, go through this
Owner’s Manual and confirm that you have all the parts shown
in each section.
Be sure to use only genuine Casablanca blades. The blade
shrink wrap holds 4 blades of matched weight. If more than
one fan is being installed, be sure not to mix blade sets.
CAUTION: When removing the shrink wrap,
be careful not to scratch the blades.
METAL DOWNROD
GASKET
RUBBER DOWNROD
GASKET
INSTALL RUBBER GASKET
Prepare the downrod as follows:
Step A. Insert the small lip of the rubber gasket into the
downrod cover.
ATTACH COVER TO DOWNROD
INSTALL METAL GASKET
Step B. Slide the downrod cover, rubber gasket first, onto the
downrod by using a twisting motion. Continue until the rub-
ber gasket is flush with the downrod ball.
Step C. Attach the metal gasket onto the downrod assembly
as shown. Using the provided screw, secure the metal gasket.
Tighten the screw by hand only.
CAUTION: Do not attach the cover onto the
downrod by pounding the downrod into the
floor. This will damage the hanging mecha-
nism and may cause the fan to fall.
19 th Century ™