Coleman 8200 Series - Manual (Page 12)

Fig 43
Fig 44
Bezel
Fig 45
Underside of
side burner
Natural Gas Conversion Instructions
8. Install the NG valve assembly to the underside
of the side burner with the two screws previously
removed (Fig. 43).
Note: Make sure the NG valve is facing towards
the front of the side burner and the valve
stem is inserted into the hole.
9. Reattach the bezel to the front of the side burner
and the NG valve with the two screws previously
removed (Fig. 44).
Note: Make sure the bezel is installed in the
correct position. The "H" will be facing
the ignitor.
10. Reattach the control knob.
11. Connect the end of the new gas supply hose to
the side burner valve assembly (Fig. 45).
12. Reattach the side burner igniter wire to the
electrode.
This completes the side burner conversion.
12
“H”
Screw