Coleman 8200 Series - Manual (Page 5)

Fig 10
Fig 14
Fig 9
Fig 11
Fig 13
Manifold
Gas Inlet Flex Line
Flex Line
Fig 12
Manifold
Screws
Natural Gas Conversion Instructions
10. Disconnect the right side flexline from the mani-
fold using the adjustable wrench. This will free
up the right side of the manifold (Fig. 9).
11. Disconnect the left side flexline from the back
infrared valve using an adjustable wrench. This
will free up the left side of the manifold (Fig. 10).
12. Remove the control knobs from the front of the
grill (Fig. 11).
13. Remove the two screws holding each bezel in
place on the control panel (Fig. 12).
14. Remove the bezels from the front control panel.
Note: The small bezel stays in place (Fig. 13).
15. Remove manifold from grill body (Fig. 14).
You are now ready to install
the new NG manifold.
5