Coleman 8200 Series - Manual (Page 4)

Fig 5
Fig 6
Side Screws
(Repeat on left side).
Screws
under lip
Fig 8
Fig 7
Tabs
Natural Gas Conversion Instructions
5. Remove the screws from the bottom of the heat
shield, holding the front heat shield in place. The
screws are located under the bottom lip of the
shield (Fig. 5).
6. Remove the two side heat shield screws
located under the bottom lip of the heat shield.
There is one screw on each side (Fig. 6).
7. Remove the front heat shield (Fig. 7).
8. Grasp and push the burner(s) towards the rear
of the grill to detach the burner from the
valves (Fig. 8).
9. Angle the burners up and remove (Fig. 8).
4