Compact Power Boxer 427W - Manual (Page 33)

6-7-06 - Fifth Proof
3-7
Pre-Start Inspection and Operation
Cylinder Lock Installation
1. Start the engine. (See Machine Start-up in this section for engine starting instructions).
2. Fully raise the loader arm.
3. Shut off the engine.
4. While holding the loose end of the cylinder lock (Item 1, Figure 3–6), pull the safety lock pin
(Item 2, Figure 3–6) outwards, releasing the cylinder lock.
5. Pivot the cylinder lock downwards to the support position (Item 3, Figure 3–6).
6. Fully reinsert the safety lock pin (Item 4, Figure 3–6), securing the cylinder lock in the
support position.
NOTE: Make sure that the safety lock pin goes behind the loader arm cylinder.
7. Lower the loader arm assembly until it is supported by the cylinder lock.
Figure 3–6 Safety Lock Installation
Cylinder Lock Removal
1. Start the engine and raise the loader arm to its full height.
2. Shut off the engine.
3. Pull the safety lock pin (Item 4, Figure 3–6) fully outwards.
4. Rotate the cylinder lock (Item 3, Figure 3–6) upwards to the storage position (Item 1, Figure
3–6).
5. Fully insert the safety lock pin (Item 2, Figure 3–6) to secure the cylinder lock in the storage
position.
2014