Clarion DXZ525 - Manual (Page 10)

14
DXZ525
English
Basic Operations
Adjusting the Z-Enhancer Plus
1. Press the [Z-E] button and select the Z-En-
hancer Plus mode to adjust.
2. Press the [A-M] button and turning the [RO-
TARY] knob clockwise adjusts in the + direc-
tion; tuning it counterclockwise adjusts in the
- direction.
● When “B BST 0” selected, you can adjust
the bass in the range of -3 to 3.
● When “IMPACT 0” selected, you can adjust
the bass and treble in the range of -3 to 3.
● When “EXCITE 0” selected, you can adjust
the bass and treble in the range of -3 to 3.
∗
When Z-Enhancer Plus is selected, press and
hold the [Z-E] button for 2 seconds or longer
to change the “CUSTOM” mode.
Bass/treble charasteristics become flat and
the indication “--FLAT--” is shown in the dis-
play.
Press the [Z-E] button again to change the “Z+
OFF” mode.
Turning on/off the loudness
The loudness effect emphasizes the bass to
create a natural sound tone. When you are lis-
tening to music at a low volume, it is recom-
mended to use the loudness effect.
1. Press the [A-M] button to select “LOUD
OFF”.
2. Turning the [ROTARY] knob clockwise or
counterclockwise to select “LOUD ON”(on)
or “LOUD OFF”(off).
When loudness effect is turned on, “LD”lights
on the display.
∗
The factory default setting is “LOUD OFF”.
Radio Operations
FM reception
For enhanced FM performance the ®
tuner includes signal actuated stereo control,
Enhanced Multi AGC, Impulse noise reduction
curcuits and Multipath noise reduction circuits.
Changing the reception area
This unit is initially set to USA frequency intervals
of 10kHz for AM and 200kHz for FM. When using it
outside the USA, the frequency reception range
can be switched to the intervals below.
● Setting the reception area
1. Press the [BAND] button and select the de-
sired radio band (FM or AM).
2. While pressing the [DISP] button, each time
you press and hold the number “6” of the [DI-
RECT] buttons for 2 seconds or longer, the
reception area switches from inside the USA
to outside the USA or from outside the USA
to inside the USA.
∗
Any station preset memories are lost when the
reception area is changed.
Listening to the radio
1. Press the [FUNC] button and select the radio
mode. The frequency appears in the display.
2. Press the [BAND] button and select the radio
band. Each time the button is pressed, the ra-
dio reception band changes in the following
order:
FM1 ➜ FM2 ➜ FM3 ➜ AM ➜ FM1...
3. Press the [ a ] or [ d ] button to tune in the
desired station.
Tuning
There are 3 types of tuning mode available, seek
tuning, manual tuning and preset tuning.