Country Home Products Garden Cart - Manual (Page 13)

CALL TOLL FREE 1-866-NEUTON1 9
CHAPTER 3
SETTING UP YOUR NEUTON GARDEN CART
Your NEUTON Garden Cart ships complete in one box. Before using your Cart, you must assemble it.
Review the checklist to make sure you have all the parts you need. Then, take some time to review the
drawings and photographs to get familiar with the steps needed to assemble your Cart. It’s much
easier to assemble your Cart once you see and understand how the parts all fit together.
Unpacking Your Cart
Open the long-end of the box with the taped closure, then lay the box down on its side with the buckets
on the bottom. Slide everything out part way — that way you can easily reach all the parts in the box.
Empty all the items from the box onto a strong table and make sure you have all the parts. Use the
pictures on the next two pages to compare.
Some Special Unpacking Instructions
•
Be extra careful with the drive train; it’s heavy, so use both hands to lift it. The drive train comes
wrapped in its own box. The battery is shipped already mounted in the drive train.
•
Clip the straps on the drive train’s box, then with its housing down, slide the drive train out.
•
The battery stays neatly nestled within the drive train’s housing. Two zip ties hold it in place for ease of
assembly later. Do not remove the zip ties at this time. The zip ties need never be removed unless you
require a replacement battery in the future.
•
The wire harness is tucked into one corner of the drive train housing. Carefully pull the wire harness out
and route it through the slot in the drive train housing. Protect the exposed electronics of the drive train
and battery until you are ready put them — as one unit — into your Cart.
•
The caddy is attached to the buckets with ties. Cut the ties to detach the caddy.
•
Leave the hardware in the separate colored bags until you are ready to use them.
•
Save the charger’s cardboard box; use it to store the charger.
•
Other than the exceptions noted above, remove all the remaining cardboard and plastic wrapping from
the parts.
•
Keep all the packing materials, including the box, until your two-year warranty expires.