Identification of parts – Perfect Aire PMP50 User Manual
Page 4
Fig. 1a -
Front
Fig. 1b -
Rear
Fig. 2 - Foam piece
inside float mechanism.
DO NOT REMOVE
the foam.
5
5
1
2
3
4
4
6
1
2
3
IDENTIFICATION OF PARTS
NOTE: All the illustrations in this manual are for explanation purposes only.
Unit purchased may be slightly different, but the operations and functions are the same.
NOTE: For continuous drainage operation, a hose no longer than 6 ft is recommended.
See page 12 for setup instructions and hose specifications if selecting continuous drainage option.
Control panel
Air intake grille
Air outlet grille
Air filter (behind the grille)
Water bucket
Handle (both sides)
Front
Continuous drain hose outlet
Caster
Power cord and plug
Band (used only when storing the unit)
Pump drain hose outlet
Rear
3
16 ft long Drain Hose (1 pc)
for pump drainage operation
Accessories:
Screw (2 pcs, 4x5/8”)
for drain hose adaptor,
continuous drainage operation
Drain Hose Adaptor A
with Short Hose (1 pc ea)
for continous drainage operation
Located inside the bucket.
Packaged on the side of the unit.
Located in the upper corner of the
packaging of this user manual.
NOTE:
Inside the bucket, on the left side, is an “arm”
mechanism that wobbles. This piece is called the
“float.”
DO NOT remove the foam piece that is
found in the cube-like part of the float.
See Fig. 2.
If the piece is removed, the bucket will overflow.