phil&teds columbus - Manual (Page 10)

THESE INSTRUCTIONS ARE IMPORTANT. PLEASE READ CAREFULLY AND
RETAIN FOR FUTURE REFERENCE.
BACKREST COVER REMOVAL. First, release the elastic strap at the bottom
of the backrest cover, Slide the cover off. The covers can now be cleaned.
HEADREST, BOOSTER SEAT COVER REMOVAL.
Slide the cover off. The covers can now be cleaned.
THE COVER SHOULD BE HAND WASH. Use only a mild hand soap and
warm water. Do not use chemical cleaners and never attempt to bleach or dye
the webbing. Allow to dry naturally.
CARE AND MAINTENANCE
NOTICE
1. This is a "Universal" child restraint; it is approved to ECE Regulation 44.04
for general use in vehicles and will fit most, but not all, vehicle seats.
2. A correct fit is likely if the vehicle manufacturer has declared in the vehicle
handbook that the vehicle is capable of accepting a "Universal" child restraint
for this group.
3. This child restraint has been declared Universal under more stringent
conditions than those applied to earlier designs which do not carry this notice.
4. If in doubt, consult either the child restraint manufacturer or the retailer.
Only suitable if the vehicle is fitted with
3-point static, 3-point retractor safety
belts, approved to UN/ECE Regulation
No. 16 or other equivalent standards.
IMPORTANT NOTE:
The child restraint must not be used without the cover.
The seat cover should not be replaced without one recommended by the
manufacturer, because the cover constitutes an integral part of the restraint
performance.
Don't use any car seat again after impact or accident.
Please remove the car seat out of vehicle when it is not used and keep out
reach of child.
Please always fasten the car seat when it is inside the vehicle.
Please always read the manual before using it, the manual is located in the
cover bag at the back of car seat.