phil&teds tott v1 - Manual (Page 6)

Step 1. Place the tott on the vehicle seat ensuring it is firmly pressed against the car seat backrest.
Step 2. Thread the car seat belt in through the hole in the seat’s plastic backrest (on car door side), and
then out through the hole on the opposite side and fasten it into the seat belt buckle.
Step 3. Check the webbing of the seat belt has not become twisted or tangled and that the lap belt goes
under the arm rest and diagonal belt covers armrest before proceeding.
Step 4. Place your knee on the base of the tott and grip the top piece of seatbelt webbing. Pull the
webbing upwards to tighten the seat belt.
Step 5. Take out all the slack in the seat belt (both the lap and shoulder sections) and ensure there are no
twists or kinks. The seat should be firmly in place before using.
fitting the seat belt lock (for use with adult seat belt)
The seat belt lock can be found inside the cover at the back of the booster cushion.
IMPORTANT: Before fitting the seat, remove the shoulder straps, crotch strap and lap strap and then fit
the seat belt lock only in the top set of slots as shown in the instructions.
Feed the diagonal portion of the adult seat belt through the seat belt lock and check that all of the slack
has been removed from the seat belt. Make sure the seat belt has not become twisted. Also check that
the cover is not impeding the movement or fit of the seat belt webbing in any way. To release your child
unfasten the seat belt in the normal way.