Potter PFC-7501 - Manual (Page 7)

3
1.6 Special Keys
POWER
TROUBLE
ALARM
COMMAND
1 2 3 4
5 6 7 8
9 0
ABC DEF GHI JKL
MNO PQR STU VWX
YX
ENABLE
SILENCE
RESET
TEST
DRILL
Fire Command Center
LCD Display
Select Keys
COMMAND Key
Back Arrow Key
Function Keys
COMMAND Key
Pressing the COMMAND key allows you to go forward through the programming menu and through each step of a
programming sec tion. As you go through the programming, the keypad display shows any current programming already
stored in the panel memory. If no change is required for a prompt, press the COMMAND key to advance to the next step.
The COMMAND key is also used to enter information into the panel memory such as phone numbers or zone names.
Press the COMMAND key after entering the information and it displays correctly on the keypad.
Back Arrow Key
Use the Back Arrow key to back up one step while in the programming menu or within a programming sec tion. The
Back Arrow key also allows you to correct an error by erasing the last character entered.
Select Keys
The top row of keys are called the Select keys. When the Programmer displays an option for you to select, such as YES
or NO, you press the Select key under the option you want to enable.
The Select keys also allow you to change programming infor mation currently in the panel memory. As you step through
each program option, the keypad displays the current information. To change this information, press the appropriate key
under the display then enter the new information
If you are changing a phone number or account number, press the Select key followed by the appropriate digit keys. If
entering a communica tion type or choosing a programming option, the keypad displays the available response options
above the Select keys. When there are more than four re sponse options avail able, the keypad dis plays the first four.
Pressing the COM MAND key brings up the next one to four options on the display. Pressing the Back Arrow key allows
you to review the previous four choices.
The Select keys are also used for se lecting a section from the pro gramming menu. This is done by pressing any one of
the Select keys when the programming section name you want displays.
Four Function Keys
The four function keys allow the user to quickly and easily perform functions on the RA-7630. The factory installed
keyswitch on the Remote Center left-hand side must be turned to the ENABLE position before the keys activate. The
keyswitch does not affect the other keys on the keyboard: They are operational at all times with a user code.
SILENCE Key—Press the SILENCE key to silence the main alarm bell and the Fire Bell Output. The SILENCE key
does NOT stop the alarm report being sent to the central station or reset any alarmed devices.
RESET Key—Press the RESET key to perform a sensor reset. Use the RESET key to reset devices such as smoke
detectors that have latched in alarm and clear the display of alarms.
TEST Key—Press the TEST key to perform a system test. This key tests the alarm bells, communication to the central
station, and the backup battery.
DRILL Key—Press the DRILL key to display SURE? YES NO. Press the select key under YES to begin the fire drill,
which sounds the main bell and activates the Fire Bell Output. Press the select key under NO to return to the status list.
Press SILENCE or enter a user code to silence the alarm bells and end the fire drill.