About the ra-7692 led keypad, Data entry keys – Potter RA-7692 User Manual
Page 13
Annunciator Manual • 8910224 • Rev C • 6/09
13
About the RA-7692 LED Keypad
This device has been placed at locations throughout the premises to
allow you to properly operate the system.
Function Keys
There are four keys under the display called the Function keys.
These keys allow you to perform system operations by pressing
one key, followed by the entry of a user code.
SILENCE Key
Press the SILENCE key to silence the alarm bells.
RESET Key
Press the RESET key to perform a sensor reset and silence the
alarm bells.
TEST Key
Press the TEST key to perform a system test.
CODE Key
Press the CODE key to change the user code.
Data Entry keys
These keys allow you to enter your user code and other
information into the system.
COMMAND Key
The COMMAND key allows you to complete a data entry function.
System LEDs
The LED Annunciator incorporates three LEDs to indicate the status
of the system. The three indicator lights are described below.
Yellow Silenced LED
ON when the system is when the bells are silenced manually from
the keypad or after the Bell Cutoff time.
OFF when a Sensor Reset is performed or if the alarm sounds again.
Yellow Trouble LED
ON when the system is unable to send a report to your central
station or when the phone line is in a bad condition.
System
LEDs
RA-7692 LED Annunciator
SPECIAL
Key
COMMAND
Key
Function
Keys
Data Entry
Keys
Zone Trouble
LEDs
Zone
Alarm
LEDs