Annunciator messages – Potter RA-7692 User Manual
Page 8
8
Annunciator Manual • 8910224 • Rev C • 6/09
Annunciator Messages
SYSTEM NORMAL
This display indicates that fire protection devices, phone lines to
the panel, and the panel itself, are in good condition.
ALARM
A fire, supervisory, or auxiliary zone has been tripped. Your
system may sound the fire bells, strobes, and any other response
programmed into the system.
ALARM SILENCED
A user has silenced the fire bells by entering the code or by using
the Alarm Silence function in the User Menu. Even though the
bells are silenced, the system is still in a state of alarm and,
depending on the annunciator model, the keypad keys will glow
red or a red LED on your keypad will flash until a System Reset is
performed (see page 2).
BYPASS
A zone has been disabled by the system due to repeated trips. If the
zone remains normal for one hour it can be restored into the system.
ENTER CODE
The system requires you to enter the user code. As you enter the
code, the display shows an asterisk (*) in place of each digit pressed.
TRY AGAIN
The user code you have entered is not recognized by the system.
Check the code and try again.
INVALID CODE
You receive this message if you enter an incorrect user code a
second time, after receiving the Try Again message.
PH LINE 1 TRBL
There is a problem with the phone line connected to your system.
Call for service as soon as possible.
TROUBLE
There is a problem with a protection device or system component.
This display is accompanied by a description of the problem.
SERVICE REQUIRED or SYSTEM TROUBLE
There is a problem on the system. Call for service.