Pro Boat PRB3550S - Manual (Page 4)

4 4
You will need to purchase the following to get your boat on the water:
4 AA alkaline batteries for the radio transmitter •
7 .2V Ni-MH Battery Pack with Deans connector (PRB3316) (2) •
OR 7 .4V 5300 25C LiPo (DYN5360D) (2)
Twin Peak Dual Battery Charger (DYN4033)
•
Tamiya/Deans adapter (PRB3312) •
PRB3316
5100mAh
Install 4 fully charged AA alkaline batteries into the transmitter,
following the instructions provided for your radio system . Be sure to
install the batteries with respect to proper polarity .
Attach the side stand pieces by interlocking them into the end pieces
as shown . Secure the interlocking pieces with medium CA or epoxy .
Make certain you allow the adhesive to fully cure before placing your
boat on the stand .
Section 2: Installing the Transmitter Batteries
Section 1: Assembling the Boat Stand
Miss Elam Brushless EP RTR •
Pro Boat radio transmitter •
Boat stand •
Additional Required Items
Contents