Pro Boat PRB3550S - Manual (Page 5)

5
Carefully remove the hatch from the hull .
The Pro Boat water-cooled ESC comes pre-wired with a Deans
connector . Use a 6-cell battery pack listed below for optimum
performance .
PRB3316 7 .2V 5100mAh with Deans connector •
OR
2-7 .4Volt 20C or higher 2S LiPo pack (DYN5360D) •
Pro Boat offers a charge adapter (PRB3312) to allow you to charge the
batteries with Dean's connectors with conventional chargers that use
Tamiya connectors .
Follow the instructions included with your fast charger to ensure a
safe charge .
Attach the hook and loop material to the batteries and the
battery boxes .
Confirm that the switch inside the boat is in the "OFF" position . Install
two fully charged 7 .2V Ni-MH battery packs into the hull .
Section 3: Installing the 7.2V Ni-MH Battery Packs
Note: Refer to the radio instructions for specific information on
transmitter setup .
Adjust both the Throttle and Steering trims to the center position . Turn
on the transmitter, then the ESC power switch . The ESC will beep until
you squeeze the throttle trigger, indicating full throttle . It may be
necessary to adjust the throttle trim knob to stop the propeller from
turning while the throttle trigger is in the neutral position .
Throttle Trim
Adjust the rudder trim knob so that the rudder is centered prior to
operation . You may adjust this control to make the boat runs straight
during operation .
Steering Trim
Section 4: Adjusting the Transmitter