Pro Boat Nitro Starting - Manual

Nitro Engine Starting Addendum
The initial starting of any ABC-style engine can be
difficult if not done with care. Please follow these
guidelines to have a successful boating experience:
Step 1
It may be necessary to loosen the glowplug a few turns
to lower the compression prior to the first run. Use the
Dynamite ® Glowplug wrench (DYN2510) to make this
task easier.
IMPORTANT: READ THIS FIRST
continued other side
Step 2
Adjust the throttle trim to allow a 1/8 open throttle
position. Place your index finger over the carburetor and
pull the pull-starter several times until you see fuel enter
the carburetor through the fuel line.
Step 3
Turn on your radio system and attach a fully charged
glow igniter (DYN1925) to the glow plug. Insert the
starting wand into the Tiger Drive and actuate the
starting switch until the engine begins to run. If the
engine does not start, place your index finger over the
carburetor and actuate the starter until you see fuel
enter the carburetor through the fuel line.