PYRAMIDA KH 60 Rustico v.2 - Manual (Page 28)

29
After the fan has been in use for a long time don’t touch
the backlights – they are hot. While replacement of lamps it
is necessary to disconnect the device from electric network.
Don’t touch the fan surface with wet hands.
Regularly clean fat filters. Don’t remove fat filters while the
fan is running.
If non-standard situation of failure arises disconnect the
device from the network and call the service center, its address
is in the warranty certificate. If you have decided that the
device is non-serviceable, make it unsuitable for exploitation:
disconnect it from the electric network, cut power cable,
remove potentially dangerous parts (it is especially important
for the safety of children who can play with unused or thrown
out devices).
After product life cycle expiry the device is liable to
particular utilization. Do not throw the device out
together with ungraded domestic waste.
If present maintenance is disregarded, manufacturer is not
responsible for possible malfunctions.
IS STRICTLY PROHIBITED!
Do not print out an extract duct to the furnace flues and gas appliances intended for heating of water and space heating,
into air ducts, designed for other devices – it may cause the ventilation and cause harm to human health.
Do not check the draft of working hood using a torch or open flame – it may cause a fire.
 Do not light a gas stove without utensils (such as for heating). Using of open fire can be dangerous and damage the
plastic parts of the hood or cause a fire.
It’s forbidden to change the design of hoods and other interventions in the product of persons not authorized by the
manufacturer for warranty repair – this can lead to disruption of extraction and reduction of safety hoods to human health.
EN
28
Single-phase network, to which a
product connects, must meet the
following requirements.
Connection should be implemented through a circuit breaker
built into the fixed wiring in your electrical panel.
All actions associated with the connection, configuration,
maintenance and repair, and replacement of bulbs can be
produced only in the absence of voltage! To do this you must
disable the electric switch on your dashboard or pull the plug.
Do not pull the plug on cord. Do not pinch or pull the network
cable.
Using of extension cords and adapters is prohibited.
Manufacturer of hood is not responsible for damage and
inflammation, which are the result from the use of tees and
extension cords. To replace a damaged power cable, call a
specialist from the service center.
Before installing, make sure that there is no visible damage
of the impeller, the body of hood, and in the absence of a
running part of the hull foreign objects that may damage the
blades of the impeller. If you have any doubts that the hood is
not damaged and fully staffed, contact the seller immediately.
Do not use the product for other purposes and subject it to
any modifications and revisions. The product is not intended
for use by children or persons with reduced physical, sensory
or mental capabilities, or if they have no life experience of
using of hood, if they are not under the control or instructed
person responsible for their safety.
Children must be under the control of adults to prevent the
gaming with the product.
Pumped air must be free of dust and other solid
contaminants, as well as sticky substances and fibrous
materials. Do not use product in the presence of flammable
substances or their vapors such as alcohol, gas, insecticides,
etc.
Do not cover or obstruct the suction and vent holes of
product, in order not to disturb the optimal air flow. Do not
reduce the diameter duct less than 120 mm.
Never hang on decorative rails on some items. This can
lead to inflammation in the process of cooking or damage to
the roof rail with heavy objects.
Under the extractor fan one cannot cook such dishes
as flamb é (dishes that are poured with alcohol and set
on fire). Watch that during cooking there is no oil ignition.
Remember that repeated use of oil increases probability of
its autoignition.
Do not leave the fan in use unattended for a long time.
OPERATION SAFETY REQUIREMENTS