PYRAMIDA KH 60 Rustico v.2 - Manual (Page 34)

35
The product complies with the requirements of
technical regulations: EMC equipment DSTU
CISPR 14-1:2004, DSTU CISPR 14-2:2007,
IEC 61000-3-2:2004 DSTU DSTU EN 61000-
3-3:2004; safety of low voltage electrical
equipment DSTU IEC 60335-2-31:2006.
Manufacturer guarantees normal operation of the product
during 24 months since the day of sale through retail
distribution network on condition that transport, storing,
mounting and exploitation regulations, stated in present
manual, are fulfilled. If your extractor fan does not work in
a proper way, call service center, maintaining TM Pyramida
products, and do not forget to report the following information:
- number of warranty policy;
- product model;
- serial number, stated on information label of the fan or in
the warranty certificate;
- failure description.
Claims won’t be considered without warranty certificate
with the date of sale and stamp of commercial organization.
At purchasing of the product press for warranty certificate
correct filling in.
Warranty service is not performed in the following cases:
- by failure to comply with rules stated in the manual;
- by reduction of the air duct diameter to less than
120 mm;
- by presence of obstacles to free air circulation from the
extractor fan to air channel exit;
- by incorrect assembly, in case of opening or wiring pod, by
replacement of the network cable;
- by supply network contradiction to the parameters set by
the manufacturer;
- by mechanical or other damages of the device as a result
of rough handling;
- by installation of the fan lower that in 60 cm from burners
and heaters.
WARRANTY
EN
34
Extractor fan is equipped with removable protective fat
filters. Filters guarantee absorption of suspended solids,
that’s why they can become dirty depending on frequency of
fan use.
To guarantee maximum capacity and efficiency of fan work, it
is necessary to regularly clean fat filters from contaminations.
Cleaning is carried out each 5-6 weeks by hand with suds
without strong mechanical effect or in dishwashing machine.
Cleaning of fat filters periodicity increase
complicates air absorption by the fan.
This leads to engine load increment and
may influence extractor fan life time.
Manual cleaning is carried out in the following order:
- remove the filter, having pressed the filter lock beforehand;
- wash the filter with cleaning agent or suds with the help
of sponge or dauber;
- thoroughly wash the filter with warm water;
- wait until the filter is absolutely dry;
- set the filter into the extractor fan, having pressed the
filter lock beforehand.
In case of cleaning with a dishwashing machine make sure
that the cleaning agents you use with your machine do not
contain deleterious substances that may damage the surface
of aluminum filter details. In the dishwashing machine, place
filters vertically to avoid food remains getting in. Before
installation of the filter into the fan after washing in the
dishwashing machine make sure that the filter is dry. In case
of failure to comply present roles the filter may be damaged!
FILTER CLEANING