Diesel – Ram Trucks 2014 ProMaster Commercial - User Guide User Manual
Page 55
MESSAGE
DESCRIPTION
Gear Not Available
This message appears, along with a warning buzzer:
•
When it is not possible to change gear due to a fault
in the system.
•
When, due a fault in the system, it is only possible
to engage 1st (1), 2nd (2), 3rd (3) or reverse (R).
Contact your authorized dealer if the message contin-
ues to appear.
Shift Not Allowed
This message appears, together with a warning
buzzer, when the system will not allow a gear change
requested by the driver (for example, that would
cause engine overspeed or transmission damage).
This message may also appear when starting the
engine at low temperature. In this case the Auto-
mated Manual transmission isn't able to engage first
gear, in this situation either use the engine block
heater or allow the engine to idle in NEUTRAL (N)
until the transmission has warmed.
Press Brake Pedal And
Try Again
This message appears accompanied, in some cases,
by a warning buzzer, if you attempt to change gear
with the vehicle parked without pressing the
brake pedal.
To shift the transmission (with key on/engine off),
press and hold the brake pedal, move the shift lever
to NEUTRAL (N), then move the shift lever to the
desired position.
Shift To Neutral
This message appears, together with a warning
buzzer, when the shift lever must be moved to
the NEUTRAL (N) position.
When the shift lever is moved to NEUTRAL (N)
the message on the display should go off.
Contact your authorized dealer if the message
continues to appear.
Press Brake Pedal
This message is shown in the display together with
an acoustic signal, when the brake pedal is
not pressed during a starting attempt.
Press Brake Shift to N key to
start
This message appears, after the door opening,
to remind to Press the Brake pedal and shift the
lever in N to permit the cranking.
DIESEL
53