RED DSMC - Manual (Page 196)

COPYRIGHT © 2015 RED.COM, INC
RED DSMC OPERATION GUIDE
955-0020_V5.3, REV-J | 196
REMOVE A LENS MOUNT
NOTE: You can change lens mounts in the field. However, RED recommends that you change lens mounts only
in dust-free environment.
REQUIRED TOOL: T20 Torx driver
1. Turn off the DSMC.
2. Attach the DSMC to a stable platform or position the DSMC on a clean and level work surface so that the
lens mount screws are accessible.
3. Remove the lens and any DSMC modules, cables, or other accessories that might interfere with removing
the lens mount.
4. Loosen and remove the four (4) M4x0.7 x 8 mm lens mount screws in a cross pattern (“X” pattern) using a
T20 Torx driver.
NOTE: Screw removal may require a large handle T20 Torx driver and additional leverage.
5. Remove the lens mount from the DSMC.
Remove the lens mount screws
Remove the lens mount