RED DSMC - Manual (Page 36)

COPYRIGHT © 2015 RED.COM, INC
RED DSMC OPERATION GUIDE
955-0020_V5.3, REV-J | 36
INSTALL THE MODULE ADAPTOR
You must install an adaptor module on the back of the BRAIN before you install a DSMC module.
REQUIRED TOOL: T20 Torx driver
1. Turn off the BRAIN.
2. Remove the REDMOTE, if attached.
3. Position the Module Adaptor over the V-mount on the rear of the BRAIN.
4. Apply pressure and tighten the four (4) captive screws in a cross pattern (“X” pattern) approximately two (2)
turns each using a T20 Torx driver. DO NOT FULLY TIGHTEN.
5. Fully tighten the four (4) screws in a cross pattern (“X” pattern) using a T20 Torx driver.
WARNING: DO NOT OVERTIGHTEN.
Install Module Adaptor
Tighten screws