RED ROCKET BREAKOUT BOX - Manual (Page 13)

DECEMBER 22, 2009 © RED.COM, INC. 2009
2-5
2.4 CONNECTION CABLES
To connect the RED Rocket Breakout Box to the RED Rocket board, special cables are used (DMS-59-
to-2×DVI-D). They must be plugged into the DMS-59 connectors located on the slot panel of the RED
Rocket board. Each DMS-59 breaks out into two (2) DVI-D (DVI for digital data only), which are then
connected to the rear of the RED Rocket Breakout Box (refer to 3.1 SETUP OF RED ROCKET BREA-
KOUT BOX).
Figure 2-3: DMS-59-to-2xDVI-D Cable
To fully connect the RED Rocket Breakout Box to the RED Rocket board, two (2) of these cables are
required. In environments where quad display applications or similar are not desired, the major connec-
tion ’DVI A/B’ to ’DVI A’ between the RED Rocket Breakout Box and the RED Rocket board will work
sufficiently (refer to 3.1 SETUP OF RED ROCKET BREAKOUT BOX). Cable specifications are detailed in
section A.1 TECHNICAL DATA.
DMS-59
DVI 2 DVI 1