RED ROCKET BREAKOUT BOX - Manual (Page 16)

© RED.COM, INC. 2009 DECEMBER 22, 2009
3-2
3.2 OPERATION OF RED ROCKET BREAKOUT BOX
The following outlines basic operation of the RED Rocket Breakout Box.
3.2.1 TURNING ON/OFF
NOTE: When the RED Rocket Breakout Box is ON and connected to the RED Rocket board, the SDI
outputs of the RED Rocket board SDI panel, located on the rear of the RED Rocket board equipped
computer, will become inoperative.
TURN ON: To turn the RED Rocket Breakout Box on, connect the 5V power adapter to the RED Rocket
Breakout Box and plug it into a power outlet.
TURN OFF: To turn the RED Rocket Breakout Box off, disconnect the 5V power adapter from the RED
Rocket Breakout Box or from the power outlet.
3.2.2 HOT PLUGGING
The RED Rocket Breakout Box is hot-pluggable, meaning it can be safely connected to or disconnected
from the RED Rocket board while both are on and operating.
3.2.3 STARTUP OF RED ROCKET BREAKOUT BOX
The RED Rocket Breakout Box does not require a special start-up procedure. When the RED Rocket
Breakout Box is properly connected to the RED Rocket board and power, it will automatically be recog-
nized by the RED Rocket board and can be used immediately.