Scientech 10K Series - Manual (Page 28)

Quick Setup Guide:
Adjust the FRONT FEET to level the balance by centering the
LEVEL INDICATOR.
5
CONNECT BALANCE
TO ELECTRICAL OUTLET
3
LEVEL BALANCE
4
UNLOCK CLAMPING SCREW
1. Remove the paper tag.
2. Turn the knob, in the direction shown until finger tight.
See page 4 of the manual.
2
PLACE IN PROPER
ENVIRONMENT
1
UNPACK BALANCE
turns but stays
but does not rotate.
The shaft moves in and out
against bottom of case.
in the same position
Thumbwheel
Calibration instructions in manual.
7
WARM UP 1 HR, THEN
CALIBRATE
Press the ON/OFF switch and make sure the balance
goes through the following sequence.
6
TURN ON BALANCE
Rotating thumbwheel('s) as
RAISES front of balance.
extend out of case and
shown causes Shaft to
28