Scientech PDA - Manual (Page 20)

20 of 27
9. The “Phone Number” window will appear.
10.
Click the down arrow in the “Connect using” box.
11. Select the correct Com port which is connected to your modem. Normally this will be “Direct to
Com 1”.
12. Click on “OK”. The “COM1 Properties” window will appear.
13.
Enter the following parameters into the port settings: (These parameters are the default parameters
of the Scientech balance when it was sent to you. If you changed the balance default parameters,
you must change them back to what is shown below. See your balance instruction manual for
guidance.)
A. Bits per second 9600
B. Data bits 7
C. Parity None
D. Stop bits 1
E. Flow control None