Shellab SVAC9-2 - Manual (Page 18)

18 | P a g e
OPERATION (CONTINUED)
S ETTING UP THE O VEN
Perform the following steps and procedures to set up the oven after installing it. See the Installation
section for power source and placement requirements, as well as vacuum source information.
1. If this is the oven’s first use, press the red control panel reset button to reset the heating
element power relays. Otherwise the oven will not be able to heat or power the Watlow
temperature controller and display.
Note: Do not press the grey Reset button on the Watlow temperature controller.
2. Push the Power Switch to the ON (I) position. The Watlow controller’s display will
illuminate and default to its home page.
3. Turn the Over Temperature Limit control knob all the way clockwise. This is
done to ensure that the Over Temperature Limit system will not interfere with the
Burn-In procedure, setting up a starting temperature set point, or the temperature
calibration process.
4. Set up the oven for use by following the procedures below after the oven has
been installed in the location where it will be used. All procedures are located in
the Operation section:
First Use Burn In (Recommended) page 19
Verify Vacuum Functionality and Integrity page 19
Setting the Temperature Controller Set Point page 20
Calibrating the Unit page 21
Setting the Over Temperature Limit Control page 22
Watlow Home Page
Current
Temperature in Red
Set Point in Green