Vermont Casting 1450 - Manual (Page 18)

18
Encore 1450 Non-Catalytic Woodburning Stove
30002425
Distance from the Center of the Flue Collar to the Wall in Top-Exit Installations
The information on this page is helpful in planning stove placement for top-exiting installations, particularly those in-
stallations with chimneys that pass through the ceiling. However, this is not a clearance chart. Final stove clearances
must adhere to the guidelines stated in the clearance chart on Page 14.
Dimensions indicated are valid for installations with either 6” or 8” flue collars.
Encore: WITH Chimney Connector Heat Shields
Unprotected Surfaces Protected Surfaces
Corner Corner
Parallel Installations Installations** Parallel Installations Installations**
Side (A) Rear (B) Corner (C) Side (D) Rear (E) Corner (F)
30¹⁄₂” 13¹⁄₄” 25¹⁄₂” 21¹⁄₂” 7¹⁄₄” 13¹⁄₂”
(775 mm) (337 mm) (648 mm) (546 mm) (184 mm) (343 mm)
**To locate center of flue collar for corner installation, add 6 ¹⁄₂ ” (165 mm) to the clearance distance from stove corner to wall.
Mark off the resulting distance from the corner along both walls. Next, measure the same distance from these two points out
from the walls. These last two measurements will meet at a point representing the center of the flue collar. Refer to the dia-
grams above.
ST632a
ST632a
Encore
flue centerline
Diagrams
02/01
A
B C D E F
Encore: WITHOUT Chimney Connector Heat Shields
Unprotected Surfaces Protected Surfaces
Corner Corner
Parallel Installations Installations** Parallel Installations Installations**
Side (a) Rear (B) Side (A) Side (D) Rear (E) Corner (F)
30¹⁄₂” 25¹⁄₄” 34¹⁄₂” 21¹⁄₂” 11¹⁄₄” 14¹⁄₂”
(775 mm) (641 mm) (876 mm) (546 mm) (286 mm) (368 mm)
* This distance, from the center of the flue collar to the front edge of the hearth, is the same for all installations on this page:
35
¹⁄₄ ” in the United States and 37 ¹⁄₄ ” (946 mm) in Canada.
ST632
ST632
Encore
flue centerline
Diagrams
2/01
*
A
B C
*
D E F