Smartek ST-X500 - Manual (Page 5)

Page4 Steam press Instruction Manual
12. The Ironing Board Cover is removable and washable for extended use.
13. The Pressing Cushion is a fabric covered pad used for pressing gathered or contoured
areas such as sleeves, darts, and yokes.
14. A plastic water Spray Bottle is used for dampening fabric before pressing.
15. A Water Container is used for filling the Water Tank.
16. Power light.
17. Temperature Ready Light.
18. Steam Ready Light.
Automatic features of the Steam Press include Auto Shut-Off and Auto Wake-up. These
multiple function safety features turn off electric power to the heater when the Pressing plate
has been left against the Ironing Board for more than 10 seconds OR if the Pressing plate is left
in the open (up) position without use after approximately 15 minutes. The heating ability of
the unit is restored when the Pressing plate is lowered or raised from its current position.
IMPORTANT NOTE: Auto Shut-Off does not mean power is totally cut off. Power is always
on, the Power Light remains on as well until the Power Switch is OFF.
To turn the power ON again, press the ON/OFF Switch to the OFF
position, then back to the ON position.
a
The following information is provided for service by a qualified electrician only:
Rated voltage: 110V/120V; 60Hz; 1300W
WARNING: This appliance must be grounded. Use only the proper type outlet when plugging in the appliance. Do not attempt to override
the ground wire feature.