Clarity C4210 - Manual (Page 25)

25
Pause Feature
Programming in a pause will cause the phone to wait
four (4) seconds before dialing additional numbers.
This feature may be used when it is necessary to dial
an access code (9, for example) and wait for a sec-
ond dial tone before you can dial an outside number.
Press the RD/P button at the required point during
the memory storage process to program a pause.
Temporary Tone
If you have rotary (pulse) dial service, you can change
from pulse to touch tone (tone) during a call.
1. Make phone call and wait until it
is connected.
2. Press the * key. Keys pressed after this are
sent as tone signals.
3. The phone will automatically reset to rotary
(pulse) service after the call ends.
Lighted Key Pad
The key pad will light for fifteen (15) seconds after
removing the handset from the base. To reactivate
the feature while in standby, press the TALK or the
MEM button. To activate while the phone is in use,
press any key.
Page/Handset Locator
To send a page signal from the base to the handset,
press the PAGE button located on the base of
the telephone. A series of rings will sound from
the handset.
To locate the handset if it is away from the base,
press and hold the PAGE button for approximately
five (5) seconds. A series of rings will sound. Return
the handset to the base or press any
button to cancel the page.
TELEPHONE OPERATIONS