Snazzy FX CHAOS BROTHER - Manual (Page 18)

then take the gate output of the chaos brother and patch it into either the CV
input of your sequencer or the CV in of a clock divider!
!
using the threshold control and CV knob you can set the chaos brother to create
rhythmic offsets ...!
!
or when using with a few dividers and sequencers, you could set up some very
elaborate. "organic" patterns!
!
!
try using the Gate out of the dreamboat to drive one divider/ sequencer and the
gate out of the chaos brother to drive another all the while driving both modules
CV inputs with gate outs from respective dividers or sequencers.!
!
please see snazzyfx YouTube channel 4 examples of this technique!
!
(channel is SNAZELLE)!
!
!
AUDIO patch:!
!
Though at times it can be hard to hear without the proper speaker the Chaos
brother , like the dreamboat , can be used as an audio source .!
!
in the case of the chaos brother connect The X output jack to your mixer. then in
order to hear the signal make sure to turn chaos to 90 to 100% and turn speed
80-100 %.!
!
you should hear a very low rumbling sound!
!
one fun patch is to take this low rumble /put it through a distortion or a processor
like the Harvestman Malgorithm or the ARDCORE bit crusher program, then feed
it into a VCA. (or use the built in VCA on the tidal wave)!
!
now take the gate out of the chaos brother and patch it into an envelope.!
take the output of the envelope and patch it into your VCA.!
!
now you are gating the low rumbling sound with the chaotic gates.!
!