Snazzy FX CHAOS BROTHER - Manual (Page 20)

!
LAST PATCH ( maybe most important!!)!
!
The one final patch that is recommended with every chaos module is <cross
coupling and or feedback patch>!
!
if you have two chaos brothers use those.... if you have one dreamboat and one
chaos brother use those... or if all you have is one chaos brother use one chaos
brother and one regular VCO!
!
!
#### what you need for cross coupling is two separate modules that have each
have a CV input and a signal out##!
!
however if you do this with two modules that are already chaotic the results can
be really really neat!
!
so quite simply we are going to label whatever two modules we use as module A
module B!
!
after I describe how to set up this patch you can go back and add VCA's to the
signal paths to allow for further control and precision!
!
you could also go back and add slews or filters or offsets or attenuverters to the
CV/feedback paths!!!
!
!
OK!
the CROSS-COUPLING/feedback patch is SUPER simple.!
!
here it is: !
1. plug the The X or Y output of module A into the CV input of module B.!
!
2.then plug the X or Y output of module B into the CV input of module A !