Solberg Scrubbers - Manual (Page 5)

Solberg Manufacturing, Inc., 1151 Ardmore Itasca, IL 60143 USA
Ph: 630.773.1363 Fax: 630.773.0727 Email: [email protected] Web: www.solbergmfg.com
Rev: MM Scrubbers May 2010
Page 5
SOLBERG
Media: Polyester
 Efficiency: 99% @ 1 micron
 Typical Element Operating Differential Pressure: 0 – 3 psig / 0 – 0.21 BAR
 Filter Change-Out Differential: 1 psig / 0.07 BAR over initial backpressure of the
saturated and dirty element
 Typically used in scrubber applications to remove fine particulate and trace
condensate
Note: Filter change-out differential pressure is ultimately determined by the Operator.
Please follow application specific guidelines.
4. Element Cleaning
Cleaning is NOT recommended for Solberg Manufacturing’s scrubber or separator
elements. Once particulate entrainment and saturation occur, it is impossible to restore
elements to their original condition. It is recommended that once maximum differential
pressure is reached, new elements should be installed.
5. Vane/Demister Pack Specifications
Material: 304 / 316 Stainless Steel
 Efficiency: 99% @ 8 micron
 Typical Operating Differential Pressure: 0 – 1 psig / 0 – 0.07 BAR
 Used in scrubber applications to remove condensate and separator applications to
remove heavy concentrations of oil
 Designed to be removable and cleanable upon request
Section C
PROCEDURES
*WARNING*
Before installing any Solberg scrubber/separator, it
is essential that all packaging materials are
removed properly, to avoid injury risk.