Sonics 2055 -Press - Manual (Page 26)

• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
I N S T R U C T I O N M A N U A L • M O D E L 2 0 5 0 / 2 0 5 5
25
3. Next rotate the cap screw down until the Pressure Switch opens.
4. Rotate cap screw down one turn past the Pressure Switch open position.
5. Tighten the jam nut to lock cap screw in position.
6. Replace pinch point cover and the side panel cover and position securely.
7. Plug the power supply into the electrical source.
8. Cycle the welder.
The press is now set to trigger at the minimum trigger pressure of 4-7 psig.
A press actuating in an upward or horizontal direction should be set to trigger
at a minimum of 8-10 psig. Lower values may affect trigger performance
where false triggering may be observed.
Go To Top Of Document