Special Projects Audio GXE lite - Manual (Page 5)

3. Quick Start Guide
 Fully charge the Evo transmitter by connecting the Evo to the supplied wall plug transformer.
Leave your Evo transmitter powered OFF while charging.
 Fully charge the Group.X or Group.X Lite Portable PA.
 Set master volume to minimum, switch Group.X portable PA power on. Leave Evo off.
 With wireless receiver turned on, but with volume turned down, set the receiver to the desired
channel. If the RF lights (with the Evo transmitter OFF), select another channel with no RF
activity.
 Turn on your Evo transmitter and select the matching channel. Note the below table describing
the channels! Note that position 0 indicates channel 16. See Section 7 for details. Also –
be sure to watch the receiver RF indicator for activity as you select the transmitter channel, as
described in the next step. If the RF lights lights fully on one switch position, you have likely
found the correct channel.
Evo Transmitter Switch Transmit Channel Evo Transmitter Switch Transmit Channel
1 1 9 9
2 2 A 10
3 3 B 11
4 4 C 12
5 5 D 13
6 6 E 14
7 7 F 15
8 8 0 16
 Raise wireless volume to approximately midway.
 Slowly raise main PA volume to desired level. If needed, wireless volume may also be
adjusted.
 If setting up a second Evo and PA receiver (optional), follow the first five steps for the second
unit before checking volume on each. It is good practice to skip at least one channel when
using multiple transmitter/receivers.
 Go forth and be truly wireless!
3