Special Projects Audio MONSTER User Manual
Page 16
7.2 Evo Headworn Transmitter Channel Set
NOTICE: Prior to setting up, please check that the transmitter and receiver are tuned to the
same frequency. Two or more transmitters operating in the same frequency can not be used at
the same time and area. So for each extra transmitter, please select a different frequency which
can be used simultaneously at local area.
Power the Evo transmitter ON by pressing the POWER button for one second.
•
Open the channel selector cover and set the rotary selector to the desired channel. Note that the
rotary selector is alpha-numeric. You may refer to the chart below:
Channel
Selector
Channel
Selector
1
1
9
9
2
2
10
A
3
3
11
B
4
4
12
C
5
5
13
D
6
6
14
E
7
7
15
F
8
8
16
0
•
Note that to set the transmitter to channel 16, you must use the '0' setting on the rotary selector.
•
When the transmitter is set to the same channel as the receiver, the receiver’s RF meter should
indicate a strong signal, regardless of whether or not you are speaking into the mic.
•
Be certain that the selector cover is securely closed prior to use. Failure to close the cover
may affect water resistance and void your warranty.
14