Specialty Concepts SC3/15 - Manual (Page 5)

INSTALLATION INSTRUCTIONS:
1. MOUNTING CONSIDERATIONS: - The SC3/15 is designed to be mounted flush
against a wall. It can be mounted onto a wall by adding the optional knockout box
(4x7 BOX). Flush mounting or wall mounting require different installation and
mounting considerations.
FLUSH MOUNT: The flush mounted unit requires a rectangular cut-out in the
mounting surface with sufficient space (2-3 inches) immediately behind to
accommodate the controller. Electrical connection is made to the back of the
controller via wires.
WALL MOUNT: The wall mounted unit (SC3/15 with the 4x7 BOX) is installed onto a
wall surface via four mounting screws. Electrical connections are made through
knockouts in the box to the wires on the back of the controller.
2. ACQUIRE TOOLS AND MATERIALS
TOOLS AND MATERIALS NEEDED:
FLUSH MOUNT:
Slotted screwdriver
Wire cutter/strippers
Drill with 3/32" and 3/8" bits
Keyhole saw or saber saw
Pencil, scratch awl or other marker
Soldering iron and solder (if available)
Electrical tape
Wire of sufficient gauge to run from the panels, to the SC3/15, and to the
battery (See INSTALLATION INSTRUCTIONS: SELECT WIRE \ WIRE
SIZE)
Mounting fasteners of appropriate type for wall material (3/4 - #6 screws
provided)
Included are wire nuts, four 3/4 - #6 screws and washers and a spare fuse (15
amp AGC).
WALL MOUNT (SC3/15 with 4X7 BOX):
Slotted screwdriver
Wire cutter/strippers
Pencil, scratch awl or other marker
Soldering iron, solder (if available)
Electrical tape
Wire of sufficient gauge to run from the panels, to the SC3/15, and to the
battery (See INSTALLATION INSTRUCTIONS: SELECT WIRE \ WIRE
SIZE)
Mounting fasteners of appropriate type to mount the box to the wall
1/2 inch Romex strain relief clamps
Included are wire nuts, four 3/4 - #6 screws and washers and a spare fuse (15
amp AGC).