Sportline Hydracoach - Manual (Page 15)

HydraCoach
Initial Setup Mode
After battery installation, the computer displays the program’s
master screen briefl y, and then automatically enters into the
Initial Setup Mode. This Initial Setup Mode may be accessed in
two ways: 1) After a battery insertion (the program will display
factory default settings), or 2) When both the Setup and Start/
Stop/Reset buttons are pressed and held simultaneously for 2
seconds (the program will display user preset settings).
The Initial Setup Mode allows you to select operational units
and enter personal data in order to customize the HydraCoach
Hydration Program to meet your needs. All steps in the Initial
Setup Mode have been preprogrammed. If an entry error is
made, complete the Initial Setup Mode program and then re-
enter from the Normal Operating Mode as described above to
revise the setting(s).
SETUP MODE BUTTON OPERATIONS
Mode Button – Toggles through units and advances digits.
Hold down for fast advance.
Setup Button – Sets units or digits and advances to the next
item or screen.
Start/Stop/Reset Button – Has no function in Setup Mode.
INITIAL SETUP MODE PROGRAM
Units of Fluid Measure
Select OZ (Ounces) or L (Liters)
as the program’s default unit of
fl uid measure. Note: The default
setting for Units of Fluid Measure is
Ounces (OZ).
15
SP3906IS0ISPORE.indd 15 3906IS0ISPORE.indd 15 10/20/08 4:38:03 PM 10/20/08 4:38:03 P