Sportline Hydracoach - Manual (Page 26)

The HydraCoach seems to be reading low.
You may be sucking too lightly. Try sucking a little harder through the
Mouthpiece. (See the Helpful Tips section in this manual for more details)
The HydraCoach seems to be reading high.
Make sure that you are not sucking any air through the system. Ensure that
there is always water contained within the Impeller Assembly and Tubing
while in use. (See the Helpful Tips section in this manual for more details)
The Computer does not register my fl uid intake after I drink
from the HydraCoach.
The Hydration Program has not been started, or is paused. (See the
HydraCoach Operation section in this manual for more details)
The HydraCoach is assembled improperly. (See the Disassembling and
Reassembling the HydraCoach section in this manual for more details)
The Impeller may be bound or seized. Check to make sure that the Impeller
spins freely within its housing.
The Computer behaves erratically, experiences “lock-ups” or the
display is weak or fades in and out.
The Battery may be weak and/or dying.
The Computer’s LCD and other sensitive components do not operate well
in extremely hot or cold conditions. Return the HydraCoach to a less
extreme environment.
Check the components for cracks or breaks, and the fi t of all assemblies to
ensure that the system is air and water tight. A system that is compromised
by air or water leaks will cause the HydraCoach to malfunction. Tighten any
loose fi ttings.
The Computer’s display is blank or does not light up.
The Battery is completely dead, not installed or the factory installed
Insulation Tab may still be inside the battery compartment. (See the Battery
Information and Installation section in this manual for more details)
It is diffi cult to suck water through the tubing and mouthpiece.
The Mouthpiece and/or Air Check Valve may not be fully cut through. Try
pinching and rolling the Mouthpiece between your thumb and index fi nger
to open the slit completely. Run a fi ngernail across the Air Check Valve to
separate the four triangular shaped fl aps from one another to allow air to
more easily pass through.
Troubleshooting
26
SP3906IS0ISPORE.indd 26 3906IS0ISPORE.indd 26 10/20/08 4:38:07 PM 10/20/08 4:38:07 P