Char-Broil TRUINFRARED 463250512 - Manual (Page 15)

15
6
On back of grill, place upper back panel between side panels and above lower back panel. Secure upper back panel in
lower holes using one 1/4-20x1½” screw and fiber washer on each side.
Do not fully tighten screws until side shelf installation is complete in later steps.
1/4-20x1½”
screw
fiber washer
1/4-20x1½”
fiber washer
screw
Door
Hinge Pin
for clarity of illustration
Note: some parts omitted
Front brace
Upper back panel
5 Insert front brace under control panel and between cart side panels. Make sure door hinge pins are on the top side and
facing the front.
Secure upper holes using one 1/4-20x1½” screw and fiber washer on each side.
Secure lower holes using one 1/4-20x1½” screw on each side.
Note: DO NOT over tighten screws and washers that come into contact with porcelain coated surfaces. Over tightening may
cause the porcelain coating to crack and break, resulting in exposed metal that will be prone to rust.