StarTech.com SV565LANDUA - Manual (Page 7)

Instruction Manual
4
3. Connect a USB keyboard and/or mouse to any of the USB Hub ports on the Remote unit.
OPTIONAL: Connect any additional USB peripherals you wish to use to the Remote unit
(install any required software as per the manufacturer’s instructions). A powered USB hub
may be connected to the Remote unit, if additional USB ports are required.
Connecting the Local Extender to the Remote Extender
LAN
1. Connect one end of a Cat5 cable or patch cord to the RJ45 connector on the Local unit.
2. Connect the opposite end of the Cat5 cable to the terminated wall outlet near the
host computer.
3. Connect one end of a Cat5 cable into the RJ45 connector on the Remote unit.
4. Connect the opposite end to the terminated wall outlet near the remote devices.
Point to Point (no network)
1. Connect one end of a Cat5 (or better) cable (up to 100m) to the RJ45 connector on
the local unit.
2. Connect the opposite end to the RJ45 port on the remote unit.
Powering the Units
1. Connect the power adapters to the Local and Remote units. Each unit uses a specific
power adapter (5VDC for Local, 24VDC for Remote). Please ensure the correct power
adapter is connected, otherwise damage may occur.
2. The “Status” LED should light up on both units to indicate power. The “Link” LED should also
light up to indicate a connection between the Local and Remote units is established.