Sure Heat BRO Burnt River Oak - Manual (Page 7)

CONNECTING GAS SUPPLY TO BURNER PAN
(If a Safety Pilot Kit is to be used, please refer to separate installation instructions). These instructions refer to the
Natural Gas applications installed without a Safety Pilot Kit. (Pilot Safety Kit available at your local dealer).
A. Place Burner Pan assembly in the center of the fireplace.
B. Attach Brass 3/8" Flared to 1/2" Gas Inlet Fitting (Part # 10) to the 1/2 inch gas supply stub.
C. Attach 3/8" Flared Tubing (Part # 12) to the 3/8" Brass orifice Elbow (Part # 11). Attach opposite end to gas supply
line by carefully bending the flared tubing as needed to make the connection. Avoid kinking the flared tubing while
bending. If tubing must be cut, use a tube cutter and flare the cut end of the tube with a flaring tool.
D. Be certain all connections are tight and use pipe compound on all male threads to seal joints. Test all connections
with a soapy water solution with the gas supply turned on. If bubble appear on any connection, re-tighten and re-test.
Once it is determined there are no leaks whatsoever, turn off gas supply and move to next assembly step.
GRANULE, EMBER AND LOG GRATE PLACEMENT
A. Spread granules (Part #14) over the installed burner pan. Granules should
not fill up the entire pan. The granules should stop 3/4" - 1" from the top of
the pan. Slope the Granules down toward the front of the pan without over
flowing them over the front lip of the burner pan. (See Fig. 8)
B. Spread glowing embers (Part # 15) over the top of the granules, covering
the entire surface area, concentrating on the front and sides of the burner
pan for the most realistic burning effect.
C. Place log grate (Part # 7) over the burner pan, aligning the front legs with
the front edge of the burner pan. (See Figure 9b).
LIGHTING YOUR GAS LOG SET
(Manual valve only)
A. Open chimney flue damper to the full open position.
B. Be sure gas supply is shut off
C. Lay match on top of embers and granules near gas burner input. Do not
hold match in hand. (See Figure 10)
D. With match burning, slowly turn on gas.
Fig. 5 Fig. 6 Fig. 7
Figure 9 (A & B). Granule, ember and
grate placement.
Figure 10. Lightingt he log set.