Tactic TTX850 8-Ch SLT Computer - Manual (Page 23)

23
6. The TTX850’s “searching” screen should disappear. The teacher can release the trainer switch. If the
TTX850 doesn’t identify the signal from the student’s radio a “NO SIGNAL” message will show.
7. Once linked, move the throttle stick on both transmitters to minimum. Turn the Rx power on and
make sure only those channels selected for transfer to the student are transferred when the TTX850
trainer switch is defl ected. Ensure the teacher can regain control of all channels when the trainer
switch is released.
8. Perform a complete range check before fl ight.
9. When the training session has ended, with the model safely landed and power removed from the
model, simply turn the power switch for both transmitters to the OFF position. This will terminate the
wireless link between both transmitters.
Teacher’s radio Tactic TTX404, 410, 600, 610 – Student’s radio Tactic TTX850
1. Link the teacher’s Tx to the Rx. Remove power from the model, and then turn the teacher’s Tx off.
2. Pull the teacher’s trainer switch and hold it in this position and turn the power switch on.
3. Move the student’s transmitter to within 3 feet of the teacher’s transmitter, turn the power switch on
and set the RF OUTPUT to ON.
4. The teacher’s LED should fl ash three times and then stay on to indicate the link was complete. Release
the trainer switch.
5. Once linked, move the throttle stick on both transmitters to minimum. Turn the Rx power on and
make sure only those channels selected for transfer to the student are transferred when the TTX850
trainer switch is defl ected. Ensure the teacher can regain control of all channels when the trainer
switch is released.
6. Perform a complete range check before fl ight.
7. When the training session has ended, with the model safely landed and power removed from the
model simply turn the power switch for both transmitters to the OFF position. This will terminate the
wireless link between both transmitters.
Teacher and student’s radio TTX850 or TTX650:
1. Link the teacher’s radio to the Rx.
2. In the teacher’s TRAINER screen described on page 10, select which channels to NOT be transferred
to the student while training, and select a switch to control the training function. Then turn the
teacher’s Tx off.
3. Move the student’s transmitter to within 3 feet of the teacher’s transmitter.
4. Pull the teacher’s trainer switch and turn the power switch on. The “searching” message should show
on screen.
5. Turn the student’s radio on, and set the RF OUTPUT to ON.
6. The teacher’s “searching” screen should disappear. The teacher can release the trainer switch. If the
teacher’s Tx doesn’t identify the signal from the student’s radio a “NO SIGNAL” message will show.
7. Once linked, move the throttle stick on both transmitters to minimum. Turn the Rx power on and
make sure only those channels selected for transfer to the student are transferred when the teacher’s
trainer switch is defl ected. Ensure the teacher can regain control of all channels when the trainer
switch is released.
8. Perform a complete range check before fl ight.
9. When the training session has ended, with the model safely landed and power removed from the
model, simply turn the power switch for both transmitters to the OFF position. This will terminate the
wireless link between both transmitters.