Tactic TTX850 8-Ch SLT Computer - Manual (Page 7)

7
LCD contrast and backlight intensity are adjustable for optimum viewing. Six pushbuttons navigate
the menus and settings. Single button pushes will result in a single incremental adjustment on-screen.
Holding a button for a short time will result in slow scrolling of adjustments; continued holding will result
in fast adjustments.
LEFT SIDE BUTTONS
Press any time to see the servo position screen. Indicators for certain channels will change
depending on model type, wing type, etc. Moving any Tx control will graphically be shown
on this screen. When setting / adjusting mixes to determine if the mix is as desired, set the mix and then
view this screen. Move all controls to determine if the mix moves each respective channel as needed.
Quickly resets certain values and settings back to factory defaults. Press to backspace in
the model and user name screens.
Jumps back to the previous screen, and removes certain pop-up messages from the screen.
RIGHT SIDE BUTTONS
Adjustment of values on-screen.
Moves the cursor up, and increases highlighted values/settings.
Moves the cursor down, and decreases highlighted values/settings.
To select or de-select a setting, or enter a screen. Press briefl y to access the SETTINGS
menu. Press and hold to access the MODEL SETUP menu.
The TTX850 has three types of menus.
The SYSTEM SETUP menu allows for setting basic operational functions for the radio itself.
Selecting and managing the model memories, confi guring the radio for the structure of the airplane, helicopter,
or multi-rotor is done in the MODEL SETUP menu. Most functions apply for all model types. Select functions
are available for certain model types only.
Setting various radio functions to control the model is done in the SETTINGS menu. Some settings apply
for all model types, while certain functions are available for certain model types only.
Fundamental settings for the transmitter itself are located in this menu. With the power switch in the OFF
position, press and hold ENTER, turn the power switch ON and wait for the SYSTEM SETUP screen to
show. Move the cursor and press ENTER to select any setting. Press
and to change settings. Press
ENTER to confi rm the setting.
HOME SCREEN LCD, PROGRAMMING CONTROLS, MENU NAVIGATION
MENUS
SYSTEM SETUP