Tactic TTX850 8-Ch SLT Computer - Manual (Page 9)

9
Changing the model memory is not possible if the Tx battery voltage is too low. See the INPUT POWER
section on page 4. It’s a good idea to keep a record of all settings in each memory as a backup in case
parameters in a particular memory are accidentally changed, etc.
MODEL MANAGEMENT
Shows basic information regarding the model setup
in the “Model” memory number at top-left. Move the
cursor up or down to select / change the function to
adjust, and press ENTER to adjust the function.
Name: With the cursor on this line press ENTER.
The method for setting the model name is the same
as for entering the USER NAME as described on
page 7. The maximum number of characters is eleven. Press ESC when fi nished.
Model Type: Press to place the cursor on this line, and ENTER to highlight the selection. Press
or to select the model type as airplane, helicopter, or quadcopter. Press ENTER to confi rm.
Model Copy: To copy all parameters from one model memory to another, place the cursor at this
line and press ENTER. The “COPY FROM” page will show. Highlight the memory to copy FROM and
press ENTER. Now the “COPY TO” page will show.
Place the cursor over the memory number to copy TO, and press ENTER. The “COPY CONFIRM”
screen will show. To abandon the copy function as shown on-screen, highlight “NO” and press ENTER
to return to the “COPY TO” screen. Press ESC to return to the “MODEL MANAGEMENT” screen.
Otherwise, press to highlight “YES” and press ENTER. All settings that previously existed in the
receiving memory will be permanently erased. The display will return to the COPY TO screen. Return
to the “MODEL SELECT” screen to confi rm the copy function was successful by looking at the memory
that was copied “to”.
Model Reset: Use this function to clear all parameters of any single memory except model type back
to factory defaults. Enter this screen, move the cursor over the memory to reset and press ENTER.
Select “NO” to cancel or “YES” to proceed with the reset, and press ENTER. The display will then
return to the “MODEL RESET” screen.
Wireless Transfer: To transfer all parameters
of one memory in this transmitter to another Tactic
TTX850 transmitter, move the cursor to this line and
press ENTER. Press or to select “Send” or
“Receive”. Press ENTER, then or to select
the model number to send or receive data. Press
ENTER to perform the function, or ESC to cancel.
WING TYPE
This is for setting the type of tail and wing confi guration for the model. Depending on the mixes used and
setup of the aircraft, it might be necessary to change the aileron, elevator, or rudder reversing settings to
achieve the proper throw directions for the model.
For best results, selecting certain tail or wing types might require some servos to be connected
to different outputs on the receiver (not the normal channel slots). The TTX850 will automatically
map all controls accordingly. See the servo connection charts in this section for details.
TAIL SETTINGS
“Normal” is the factory default setting for the “TAIL” type. Move the cursor over “Normal”, press ENTER
then or to select from V-Tail, Delta (elevon), and 2 Elevator options. Press ENTER to confi rm the
selection. The charts below can aid in determining the preferred tail and fl ap setting for the model.
Model :OO Name : Sensei SS1
Model Type : Airplane
Model Copy
Model Reset
Wireless Transfer
Model Management
Send OO Sensei SS1
Receive OO Sensei SS1
Transferring .
Wireless Transfer