Inputs and outputs – TC-Helicon Play Acoustic - Reference Manual User Manual
Page 12
Play Acoustic – Reference manual (2014-07-16) 10
Play Acoustic – rear panel
Inputs and outputs
Connectors are described from right to left. For
setup examples, see “Connection diagrams”.
MIC connector
This is where the magic happens!
Plug your dynamic, condenser, icrophone in here. Remember to set the mi-
crophone type and level correctly, as described
in the Play Acoustic Quick Start Guide.
GUITAR IN connector
Connect your guitar to this input.
AUX connector
Use a 1/8” cable to connect any music source
you want to use to your Play Acoustic (especially
that 8-Track from your 1974 Comet). When an in-
put is detected here and no guitar is plugged in,
Play Acoustic will use the music signal to figure
out key and scale information.
GUITAR DI (R) and VOICE
(L) output connectors
These are the main output connectors of your
Play Acoustic. By default, mono vocals are sent
via the Voice (L) connector, and a mono guitar
signal is sent via the Guitar DI (R) jack. This con-
figuration can be changed in the Setup/Output
menu.
GND switch
This is a ground lift switch. If you experience hum
while using Play Acoustic, try pressing the GND
switch to reduce or remove the hum.
Headphones connector
Connect your headphones to the Phones con-
nector.