TC-Helicon VoiceLive Rack Full User's Manual - Manual (Page 42)

41
The Setup Button
The MIDI Tab
f CHANNEL
Sets the MIDI channel that VoiceLive Rack uses
for preset change and MIDI harmony control.
When a NATURALPLAY preset is set to MIDI
NOTES 4 CH, the channel selected is the
channel used for VOICE 1. The MIDI channel for
VOICE 2 is the selected MIDI channel + 1, VOICE
3 is +2, VOICE 3 is plus 3.
f FILTER
Allows MIDI Program Change or System Exclu-
sive messages to be ignored for convenience.
f CC CHAN
Sets a separate MIDI channel for CC control if
desired.
f TRANSPOSE
This transposes the harmony voices in MIDI
NOTES mode to allow it to be controlled by
upper or lower sections of a MIDI keyboard if
required. The value corresponds to octaves.
f SPLITDIR
(Split Direction) Sets whether MIDI notes
ABOVE or BELOW the split point are used to
control MIDI NOTES presets only.
f SPLITNOTE
Sets the MIDI note above or below which the
keyboard split will be active.
f SYSEXID
(MIDI System Exclusive ID number) When ad-
dressing multiple VoiceLive Rack units on the
same MIDI In/Thru chain with a Sysex editor, each
one should have its own ID or they all will be
edited in the same way.
f VIBBOOST
Specifies how the Mod Wheel message affects
vibrato if it is enabled in a preset. The Boost
setting (default) will add more vibrato once the
part of the wheel movement reaches the corre-
sponding amount of vibrato and then returns to
the original amount at rest position. The Manual
setting allows full range control of vibrato once
the wheel is moved. To restore the factory vibrato
amount, recall the preset.
f PBRANGE
(Pitchbend Range) Sets the range in semitones
that MIDI pitch bend information will alter voice
pitch shifts.