Function set 2, Rpm unit counter distance counter – TeeJet LH 1000 User Manual
Page 10
O
PERATING THE
LH 1000
LH 1000 O
PERATORS
& F
ITTING MANUAL
10
LH A
GRO
FUNCTION SET 2
As mentioned in the introduction, the LH 1000 has 2 function sets. To select
function set 2 a working width of 9999 must be encoded, do as follows:
Press the shown keys in this order.
The following functions are now available:
RPM
Key
Function
Pressing this key displays RPM if the following conditions are met:
!
Function set 2 has been selected.
!
An RPM sensor is connected to the wheel sensor input.
!
There is only 1 magnet fitted per revolution.
UNIT COUNTER
Key
Function
Pressing this key displays units counted if the following conditions are
met (one unit is counted each time a magnet passes the sensor):
!
Function set 2 has been selected.
!
A wheel sensor where units are to be counted has been fitted.
The unit counter can be reset in the same manner as the area total
counter.
DISTANCE COUNTER
Key
Function
Pressing this key displays the distance measured in metres if the
following conditions are met:
!
Function set 2 has been selected.
!
The wheel circumference is encoded in centimetres.
The distance counter can be reset in the same manner as the area trip
counter.