TeeJet FieldPilot Install John Deere 9x00-9x20 - Manual (Page 29)

25
FieldPilot ®
98-05217 R3
14. installatiOn OF engage/disengage sWitch
Connect item (A) to the connector on the SCM harness labeled Remote Engage/Disengage. Install the push
button in a location that is easily accessible during operation of the machine. This switch (A) is not required if the
optional foot switch 32-04020 is used.
Figure 1-27: Engage/Disengage Switch
15. recOMMended electrOnics installatiOn
The Steering Control Module (SCM) should be mounted securely to the floor of the cab as far forward in the
cab as possible. The control console can be mounted to the operator’s preference. The GPS antenna should be
mounted near the nose of the vehicle on a metal surface of at least 4” square.
The Articulated Gyro Module (AGM) should be mounted towards the rear of the vehicle on a flat surface that
is horizontal to the ground. Plug the CAN extension cable to the AGM Harness (45-07716) as well as the CAN
terminator. Route the other end of the CAN extension cable towards the cab and connect to the CAN on the SCM
harness.
Figure 1-28: Recommended Electronics Installation
Gps aGM