TeeJet FieldPilot Install Willmar 7200/50 & 7400/50 - Manual (Page 16)

www.teejet.com
15
FieldPilot ®
9. install steering disengage switch (kit 91-07011)
The steering disengage kit (W) is used to automatically disengage FieldPilot when the steering wheel is
turned. The magnets mount on the steering shaft and the sensor detects the rotation of the shaft. Set the
clearance between the sensor and magnets to 1/8” and rotate the steering wheel in both directions to be
sure that the sensor does not contact the magnets or the shaft. Connect the sensor to the Steering Control
Module Cable labeled ‘Steering Wheel Sense’ and secure the cables in position so that they cannot interfere
with the rotation of the steering shaft.
Figure 1-12: Install Steering Disengage Switch (Kit 91-07011)
10. recOMMended electrOnics installatiOn
The SCM should be mounted as far forward in the cab as possible. The control console can be mounted
to the operator’s preference. The GPS antenna should be mounted hood on a metal surface of at least 4”
square. The AGM (V) should be mounted on the rear portion of the machine.
Figure 1-13: Recommended Electronics Installation
Gps
AGM
AGM